Table of Contents
Advertisement
6
WARNING
Disconnect the machine from power source whenever
adjusting or replacing any parts.
CHANGING THE FILTERS
Refer to Figure 9
The inner and outer filters should be replaced and / or
6
cleaned depending on the amount of usage and the
environment of your workshop. Clogged filters will reduce
the amount of air circulation.
• Lift up on the clips located at the top and bottom of the
cabinet and remove the outer filter.
• Pull the inner filter from the cabinet. The inner filter can
be blown out with air or washed to extend its life. The
filter should be completely dry before reinstalling into the
unit.
• Insert the new or cleaned inner filter and then install the
new outer filter. The arrow on the outer filter indicates
the air flow direction, ensure the filter is positioned
properly.
Figure 9
Clip
Arrow
MAINTENANCE
FUSE REPLACEMENT
The fuse/fuse cap is located on the rear of the unit in the
control panel. Replace the fuse if needed.
• Turn the fuse cap counterclockwise with a Phillips head
screwdriver. Pull the fuse cap and fuse away from the
control panel.
• Insert a new fuse (UL250V2A) into the fuse cap and
place the fuse cap into the control panel. Turn the fuse
cap clockwise to secure into place.
REMOTE CONTROL BATTERY
REPLACEMENT
• Remove the battery compartment cover on the
remote control.
• Replace the batteries. Ensure the batteries are
oriented as shown inside the battery compartment. Use
AA batteries (Not Included)
• Replace the battery compartment cover.
NOTE: When disposing batteries, think of the protection of
the environment. Check with your local authorities for an
environmentally safe way for battery disposal.
Inner
Outer
Advertisement
Table of Contents
