Table of Contents
Advertisement
INSTALLATION
Refer to Figure 1 to 4
This air filtration system is specifically designed to circulate
and filter non-metallic dust, which is generated throughout
the work area. The unit can be located on a work bench or
hung from an overhead support. When selecting a location
ensure the power source is easy to access. Use the carry
handle when moving the unit.
IMPORTANT: When determining a location for the air
filtration system, always select a location where the air
flow is unrestricted. Locate the unit away from corners and
any heating or cooling vents.
CAUTION
Clamp the air filtration system in place if using on
sawhorses or a workbench.
Work Bench Location
• Place the air filtration system onto a work bench, ensure
the air flow is not restricted and the unit is away from
corners and any heating or cooling vents.
• Plug the power cord into the correct receptacle. (Refer
to Power Source paragraph in this section of the
manual.)
Hanging Mount
Tools required for assembly:
No. 2 Phillips screwdriver (not supplied)
10 mm wrench (not supplied)
NOTE: Hang the unit at least 7 Feet above floor level and
away from corners and any heating or cooling vents.
• Remove four screws from the cabinet top (Figure 2).
• Thread the flange nut almost all the way up on to the
eye bolt (Figure 3).
• Thread the eye bolt into the hole on the cabinet top.
Tighten flange nut against the cabinet top. Hold the eye
bolt so it does not spin while tightening the flange nut.
• Repeat for remaining three eye bolts.
• Anchor the four mounting screws into the building's
ceiling joist. Never mount to surface such as dry wall or
false ceiling grids, etc (Figure 4).
CAUTION
Mounting hooks must be anchored to a building
structure which can support a minimum of 100
pounds. Never mount to surface such as dry wall or
false ceiling grids, etc.
• Place a hook chain on each mounting screw (Figure 4).
• Attach each eye bolt to the hook chain (Figure 4).
• Ensure the unit is level horizontally. Adjust if needed.
• Plug the power cord into the correct receptacle. (Refer
to Power Source paragraph in this section of the
manual.)
Figure 2
Screw
Figure 3
Figure 4
Mounting Screw
Hook Chain
Eye Bolt
Eye Bolt
Flange Nut
3
Advertisement
Table of Contents
