Casio XJ-A130 User Manual page 28

Problem
The remote controller
does not work.
The TEMP or LAMP
indicator is flashing or
lit.
Lamp does not light.
Important! Important! Important!
 Try performing the following steps, which may or may not return the projector to normal
operation.
1. Unplug the AC power cord and wait for at least 10 minutes.
2. Plug the power cord back in and turn the projector back on again.
 If normal operation does not resume after you perform the above steps, take the projector to
your retailer or authorized CASIO service center.
Cause and Recommended Action
The remote controller batteries may be dead.
➔ Replace the batteries (see "Replacing Remote
Controller Batteries").
The remote controller may be too far from the projector.
➔ Make sure the remote controller is within the
allowable range when you operate it.
➔ See "Error Indicators and Warning Messages".
The lamp may be defective.
➔ Contact your original dealer or authorized CASIO service center for
replacement.
E-27
Troubleshooting
See
page E-13
User's Guide
(UsersGuide_
English.pdf)
User's Guide
(UsersGuide_
English.pdf)