Advertisement
Electrical Connections
SIDE VIEW
18.8mm 17.5mm
Analogue 1-10V
Control Module
30mm
(Height = 22mm)
Mains Supply
OneSwitch Input
for manual control
Mounting Details
The MLSM2000A Control Module is designed to be mounted within the luminaire on fixing centres of 135mm.
Connections to the control module as shown above should be made using single-core wire (0.5-1.5mm ).
The interconnect cable between the detector head and the control module should be routed away from other luminaire
internal wiring and away from the lamp end-caps.
The recommended position for the detector is in the middle of the luminaire. Where this is not possible and the detector
is fitted near one end of the lamps, please ensure that the detector is at the 'cold' end of the lamps.
The DHW/S Mini Head should be mounted such that only the raised front section of the bezel protrudes through the
cut out in the louvre or infill panel. This should be constructed in accordance with the dimensions above.
Installation Guidelines
1. The Mini Detector Head must be mounted within the luminaire. Do not mount remotely.
2. The connecting cable must not be extended.
3. Artificial light illuminating the Mini Detector Head must only be reflected from the room - i.e. there must be no direct
illumination.
4. In order to achieve satisfactory light-level regulating operation, a detector must observe a substantially greater
proportion of artificial light from the luminaire(s) under its control than from neighbouring luminaires not under its
control. This is particularly important when planning the installed layout of linear luminaires that have an integral
detector positioned at one end.
TOP VIEW
21.3mm
21.5mm
14.9mm
32mm
21.5mm
Mini Detector
Head
Control Module Part No
MLSM2000A
_
}
Analogue
1-10V
Operating voltage 230V 50Hz 10%
Control
+
Power consumption: <2W
tc 70 C
Neutral
Max Load (Live OUT): 2 Amps
Max Number of Ballasts: 4
TM
OneSwitch Input
For use only with electronic, high-frequency
ballasts
Live OUT
Please read instructions prior to installation
Ex-Or Limited, Haydock Lane, Haydock
Live IN
Made in EC
Merseyside, WA11 9UJ Tel. 01942 719229
135mm
147.5mm
_
}
Analogue
1-10V
Control
+
Neutral
TM
OneSwitch Input
Live OUT
Live IN
Analogue 1-10V Ballast(s)
_
}
Analogue
1-10V
Control
+
Neutral
Live IN
800mm
Flying Lead
MLS Bus
Polarity Free
+ _
Detector
Connection
MLS Bus
Polarity Free
To next
MLS device
RJ12
Plug
2
Advertisement
