Advertisement
Technical Data
MLS CABLE: 1.5mm unscreened twisted-pair: see Application Note AN4001
MAXIMUM RECOMMENDED MOUNTING HEIGHT: 3.0m
RANGE: Cone-shaped detection pattern, diameter (at floor level) = 2.4 x mounting height
OPERATING VOLTAGE: 230V 50Hz (UK & Europe)
o
ta = 0 - 50 C
CAPACITY: Total load must not exceed 2 AMPS, up to 4 Ballasts MAX
Electronic, high-frequency ballasts ONLY
INTERCONNECT CABLE TEMPERATURE RATING: 60 C
COLOUR: White RAL9010 or silver bezel (DHW = White, DHS = Silver)
MATERIAL: UV stabilised polycarbonate (DHW/DHS)
Flame retardant PC/ABS (MLSM2000A)
IP RATING: 20
OVERALL DIMENSIONS: 32 (l) x 21.5 (w) x 21.3 (h) mm (DHW/DHS)
WEIGHT: 32g (DHW/DHS)
48g (MSM2000A)
Important Additional Notes
1.
A means for disconnection must be incorporated in the fixed wiring in accordance with the current wiring regulations.
2.
The dimming control output should be connected only to the control input of the ballasts - never to other detectors.
3.
This equipment should be used to control only those ballasts powered from the same phase as the detector.
4.
Do not connect mains to the MLS bus.
5.
It is imperative that the MLS bus is wired with the correct type of cable; normally it should be 1.5mm unscreened twisted pair. Please read
Application Note AN4001 for more details.
6.
Due to the fact that the photocell is on the ceiling looking down, it is not possible for measurements made with a lux meter on the working plane
to remain constant when daylight illuminates the ceiling and the working plane to a differing extent. Therefore, products of this type should be
regarded as capable of maintaining an APPROXIMATE light level only.
7.
This equipment switches lights no more frequently than would a responsible human occupant. However, manufacturers of some lighting types
(e.g. '2D' luminaires) may specify a maximum number of switching cycles in order to achieve a predicted lamp life. Please check with the
manufacturer of the luminaires to ensure that they are compatible with automatic controls in this respect.
8.
Some devices in this product range feature a silvered surface finish; this is intended for decorative purposes only . Care should be taken to
avoid accidental separation of the silvered coating from the product. If the unit is built into a luminaire that is subsequently wrapped in film
having adhesive properties, it is recommended that a layer of suitable packaging material be used to protect the silvered area.
Honeywell Ex-Or
St. Marks Court, North Street,
Horsham, West Sussex, RH12 1BW, UK
Tel: +44 (0)1942 719229
Fax: +44 (0)1942 508753
Email: technicalsales.ex-or@honeywell.com
www.ex-or.com
2
2.5m
6.0m
147.5 (l) x 30 (w) x 22 (h) mm (MLSM2000A)
o
2
At the end of their useful life
the packaging and product
should be disposed of via a
suitable recycling centre.
Do not dispose of with normal
household waste.
Do not burn.
W4205I
Advertisement
