Service Devices; Product Specific Devices - Nokia 6600 slide Service Manual

RM-414; RM-570
Service Devices and Service Concepts

Service devices

Product specific devices

The table below gives a short overview of service devices that can be used for testing, error analysis, and
repair of product RM-414; RM-570. For the correct use of the service devices, and the best effort of workbench
setup, please refer to various concepts.
Issue 2
FS-87
• FS-87 is equipped with a clip interlock system
• provides standardised interface towards Control Unit
• provides RF connection using coupler
• multiplexing between USB and FBUS media, controlled by VUSB
Note: FS-87 must not be used for EM-calibration.
MJ-183
MJ-183 is meant for component level troubleshooting.
The jig includes an RF interface for GSM, WCDMA and Bluetooth. In
addition, it has the following features:
• Provides mechanical interface with the engine module
• Provides galvanic connection to all needed test pads in module
• Multiplexing between USB and FBUS media, controlled by Vusb
• MMC interface
• Duplicated SIM connector
• Connector for control unit
• Access for AV- and USB connectors
RJ-227
RJ-227 is a rework jig used when servicing the BTHFM module (D6000).
It is used together with the ST-70 rework stencil.
RJ-230
RJ-230 is a soldering jig used for soldering and as a rework jig for the
engine module.
COMPANY CONFIDENTIAL
Copyright © 2009 Nokia. All rights reserved.
Flash adapter
Module jig
Rework jig
Soldering jig
Page 2 –5