Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Trotec PWLS 10-50S
Summary of Contents for Trotec PWLS 10-50S
- Page 1 PWLS 10-50S OPERATING MANUAL LED CONSTRUCTION SITE SPOTLIGHT...
-
Page 2: Table Of Contents
Do not leave the device unattended during Information marked with this symbol indicates that the operation. operating manual must be observed. • Check the device for potential damage before each application. Do not use any defective devices or device parts. LED construction site spotlight PWLS 10-50S... - Page 3 Personnel qualifications Note the information regarding transport and storage of People who use this device must: the device. • have read and understood the operating manual, especially the Safety chapter. LED construction site spotlight PWLS 10-50S...
-
Page 4: Information About The Device
The device is equipped with two additional safety sockets to which further devices can be connected. The device is dust- and splash-proof. Designation Surface LED Transport handle On/off switch Edge protection Safety sockets (connections for external devices) LED construction site spotlight PWLS 10-50S... -
Page 5: Transport And Storage
Permitted ambient temperature (when 0 °C – +45 °C stored) Operating temperature -20 °C – +45 °C Permitted ambient conditions (RH) 30 – 70 % Type of protection IP54 Protection class Safety sockets Fusing 16 A Nominal voltage 250 V Type of protection IP54 LED construction site spotlight PWLS 10-50S... -
Page 6: Start-Up
Please proceed as follows to make the device ready for operation: 1. Unfold the transport handle (2). ð The transport handle can be locked in one of the five positions. LED construction site spotlight PWLS 10-50S... -
Page 7: Operation
4. Set the on/off switch (3) back to position I. ð The device switches on in level 2. The surface LED (1) is illuminated. 5. Repeat the first two steps to connect a second power cable to the second socket (5). LED construction site spotlight PWLS 10-50S... -
Page 8: Available Accessories
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. • The LEDs are defective. They cannot be replaced. Contact the Trotec customer service. LED construction site spotlight PWLS 10-50S... -
Page 9: Disposal
Only for United Kingdom According to Waste Electrical and Electronic Equipment Regulations 2013 (2013/3113) devices that are no longer usable must be collected separately and disposed of in an environmentally friendly manner. LED construction site spotlight PWLS 10-50S... - Page 10 Trotec GmbH Grebbener Str. 7 D-52525 Heinsberg +49 2452 962-400 +49 2452 962-200 info@trotec.com www.trotec.com...