Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Trotec PWLS 10-150
Summary of Contents for Trotec PWLS 10-150
- Page 1 PWLS 10-150 OPERATING MANUAL LED CONSTRUCTION SITE SPOTLIGHT...
-
Page 2: Table Of Contents
• Insert the mains plug into a properly secured mains socket. • Allow the device to cool down before transport and/or maintenance work. • Do not use the device in aggressive atmosphere. LED construction site spotlight PWLS 10-150... - Page 3 If you store or transport the device improperly, the People who use this device must: device may be damaged. • have read and understood the operating manual, especially Note the information regarding transport and storage of the Safety chapter. the device. LED construction site spotlight PWLS 10-150...
-
Page 4: Information About The Device
Central locking screw Foot On/off switch Position I = low brightness level Position II = high brightness level Scope of delivery • 1 x LED construction site spotlight • 1 x Manual Designation Transport handle Surface LED Locking screw LED construction site spotlight PWLS 10-150... -
Page 5: Transport And Storage
Before transporting the device, observe the following: • Switch the device off. • Allow the device to cool down. • Hold onto the mains plug while pulling the power cable out of the mains socket. LED construction site spotlight PWLS 10-150... -
Page 6: Start-Up
7. Lock the new position of the surface LED (2) by turning the 3. Loosen the locking screw (3) on both sides of the device by central locking screw (5) in clockwise direction. turning in counter-clockwise direction. LED construction site spotlight PWLS 10-150... -
Page 7: Operation
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. • The LEDs are defective. They cannot be replaced. Contact the Trotec customer service. LED construction site spotlight PWLS 10-150... -
Page 8: Maintenance
Make sure that no moisture enters the housing. Protect electrical components from moisture. Do not use any aggressive cleaning agents such as cleaning sprays, solvents, alcohol-based or abrasive cleaners to dampen the cloth. • Dry the device with a soft, lint-free cloth. LED construction site spotlight PWLS 10-150... - Page 9 Trotec GmbH Grebbener Str. 7 D-52525 Heinsberg +49 2452 962-400 +49 2452 962-200 info@trotec.com www.trotec.com...