FORM FIT HDW 5M 05 Quick Start Manual

FORM FIT
HOOD PROTECTOR
Chevrolet Heavy Duty Truck 2005-
Thank you for purchasing a form fit hood protector.
Care Instructions
Clean the protector with a mild soap and water solution or plastic cleaner only.
Periodically check to make sure all the hardware is in place and the protector is secure.
Attention!
Do not use chemicals or solvents. Avoid using automatic car washes. Do not pull on the
protector when opening or closing the hood.
Hardware Kit
x 5 x 5
Tools Required
Installation Instruction
1. Open the hood. Be sure that the hood is clean and dry inside and out.
2. Center the protector on the hood to familiarize yourself with the mounting holes
locations.
3. Set the protector aside. Press the expansion plugs into the holes determined in step two.
4. Re-place the protector on the hood with the expansion plugs centered in the mounting
holes.
5. Assemble the washers onto the screws (rubber side toward protector) and insert the
screws through the protector into the expansion plugs. Adjust the protector for best fit
then, tighten the screws into the expansion plugs (do not over tighten). See Illustration
below.
Note: Do not pull on the protector when opening or closing the hood.
Illustration: Hardware Assembly
Made in Canada
HDW 5M 05
x 5 # 10 x 5/8'' Screws
#
2
Hood
Expansion Plug
Protector
Washer
Screw
Rev0.050131
FORM FIT
HOOD PROTECTOR
Chevrolet Heavy Duty Truck 2005-
Thank you for purchasing a form fit hood protector.
Care Instructions
Clean the protector with a mild soap and water solution or plastic cleaner only.
Periodically check to make sure all the hardware is in place and the protector is secure.
Attention!
Do not use chemicals or solvents. Avoid using automatic car washes. Do not pull on the
protector when opening or closing the hood.
Hardware Kit
x 5 x 5
Tools Required
Installation Instruction
1. Open the hood. Be sure that the hood is clean and dry inside and out.
2. Center the protector on the hood to familiarize yourself with the mounting holes
locations.
3. Set the protector aside. Press the expansion plugs into the holes determined in step two.
4. Re-place the protector on the hood with the expansion plugs centered in the mounting
holes.
5. Assemble the washers onto the screws (rubber side toward protector) and insert the
screws through the protector into the expansion plugs. Adjust the protector for best fit
then, tighten the screws into the expansion plugs (do not over tighten). See Illustration
below.
Note: Do not pull on the protector when opening or closing the hood.
Illustration: Hardware Assembly
Made in Canada
HDW 5M 05
x 5 # 10 x 5/8'' Screws
#
2
Hood
Expansion Plug
Protector
Washer
Screw
Rev0.050131