Oiling System
Oil Control Settings
•
Moderate applications
1. Oil control setting
Powerhead oil programming labels are provided
to identify EMM oil programming. Install the cor-
rect label to alert user to specific oil requirements.
1. Evinrude/Johnson XD30 outboard lubricant (TC-W3)
YELLOW label
2. Evinrude/Johnson XD100 outboard lubricant (Premium)
BLUE label (Installed)
An XD100 Outboard Oil Decal, P/N 352369, is
available to label boats equipped with outboards
170
1
008580
1
2
002507
that have been programmed for the reduced oil
injection ratio.
This outboard has been programmed for
the use of Evinrude
outboard oil ONLY.
Failure to use Evinrude
XD100™ outboard oil may harm engine
performance and shorten engine life.
XD100 Outboard Oil Decal
Install decals in a highly visible location, such as
one of the following:
•
Dashboard/deck of boat, next to key switch
•
Deck of boat, next to the remote oil fill
•
Deck of boat, next to oil tank assembly
•
Oil tank cover
•
Cover of oil tank compartment
•
Attach to oil tank or oil fill cap.
IMPORTANT:
Make sure the engine label and
boat decals match EMM programming.
Break-In Oiling
NOTICE
The operator must monitor the oil tank level
to confirm oil consumption. This may require
several hours of operation above idle.
IMPORTANT:
DO NOT add oil in the fuel tank on
Evinrude E-TEC models.
The EMM automatically supplies extra oil to the
engine as follows:
•
40 – 90 HP: First two hours above 2000 RPM
Follow these steps for outboard set-up:
•
Use Evinrude Diagnostics software to make
sure the break-in program has been started on
a new outboard.
®
®
/Johnson
XD100™
®
®
/Johnson
355627
355627