Oiling System
Components
If outboard has been run for more than 3 hours
with NO OIL faults (codes 34 & 117), the EMM
Activates SHUTDOWN
Stores service code 33
EMM LED 4: FLASHING
Engine Monitor NO OIL display: FLASHING
Cylinder and Crankcase
The oil distribution manifold provides crankcase
lubrication through oil distribution hoses and
pressed-in fittings on the crankcase and cylinder
block.
3-Cylinder Models
1
1
1
1. Crankcase oil fittings
1
1
1
1. Cylinder block oil fittings
168
2-Cylinder Models
1
1
1. Crankcase oil fittings
1. Cylinder block oil fittings
006758
Oil Recirculation System
External
hoses
der/crankcase passages, and intake manifold pas-
sages are used to recirculate any accumulation of
oil from various locations in the powerhead. The
movement of oil is controlled by check valves.
Cylinder Recirculation
Internal powerhead oil drain passages connect
the intake port areas of the cylinders to circulate
residual oil in the block.
External fittings and in-line check valves on each
006759
side of the cylinder block control the movement of
oil from the lower cylinder port to the upper cylin-
der port.
1
1
and
fittings,
internal
006614
006615
cylin-