Wiring; Connecting Gnd; Connecting Power Cord; Connecting Ethernet Port - IC Realtime PWR-POE-8-V3 Quick Start Manual

4.1 Connecting GND (Ground)
A Devices GND connection is important for device lightning protection and anti-interference. The
steps for connecting the GND are as follows:
Step 1 Remove the ground screw on the device. Pass the ground screw through the round hole of
the OT terminal of the ground cable. Turn the ground screw clockwise with a Phillips screwdriver to
fasten the OT terminal of the ground cable.
Step 2 Wind the other end of the ground cable into a circle with needle-nose pliers.
Step 3 Connect the other end of the ground cable to the ground bar, turn the hex nut clockwise
with a wrench to fasten the other end of the ground cable to the ground terminal.

4.2 Connecting Power Cord

Before connecting the power cord, make sure that the device is properly grounded.
Step 1 Connect one end of the power cord into the power jack of the device .
Step 2 Connect the other end of the power cord to the external power socket.

4.3 Connecting Ethernet Port

Ethernet port uses standard RJ-45. Using the self-adaptation function, it can be automatically
configured to full duplex/half-duplex operation mode. It supports MDI/MDI-X self-recognition of
the cable, therefore, you can use cross-over cable or straight-through cable to connect terminal
device to network device.

4 Wiring

Figure 4-1 Connect GND
5