Page 1
ALL-CeRAmIC vACuum ToILeT vacuFlush 3000, 3100, 3300, 3400 Series Toilets ® 3000 Series IMPORTANT NOTICE VacuFlush sanitation systems must be installed according to Dometic’s recommended procedures. Do not attempt installation without first contacting a VacuFlush Certified Dealer, your nearest VacuFlush Parts Distributor, or Dometic.
4. Never use drain openers, alcohol, solvents, etc. in the system. 5. If the system does not function properly, refer to the Troubleshooting section of this manual and repair as necessary. If problem persists, contact your local SeaLand dealer or see the Customer Service section of this manual.
opeRATING INSTRuCTIoNS 1. Adding more Water To Toilet bowl Raise flush handle or press “Add Water” switch until desired water level is attained. To prevent toilet overflow, the control module limits the amount of water that can be added. 2. Flushing The Toilet When the vacuum status panel’s green “OK to Flush”...
SANITATIoN SYSTem CompoNeNTS Vacuum Toilet: VacuFlush all-ceramic vacuum toilets with technology operate differently compared Flush and Forget ® to other toilets. The vacuum system uses a small amount of water (a little more than a pint or .5 liter) per flush in addition to a simple vacuum.
Replacement cartridges are available. Holding Tanks (marine option only – not shown): SeaLand holding tanks are made of super-strong, 3/8” (0mm) thick polyethylene — 50% thicker than most other holding tanks. Each features solid, one-piece construction with no seams for unmatched durability.
mARINe SANITATIoN ReGuLATIoNS All boats with fixed toilets in U.S. waters and in the waters of some other countries are required to be equipped with an operable marine sanitation device (MSD). The VacuFlush vacuum sanitation system, when installed in a boat, is a holding tank or Type III system as defined by the U.S.
mANuAL FLuSH opeRATIoN In the event of an electrical failure, the flush ball can be manually operated to clear the bowl. We recommend using a long-neck screwdriver or 7/16-in. socket for the operation shown below. NEVER PRY OPEN THE FLUSH BALL FROM INSIDE THE TOILET BOWL.
TRoubLeSHooTING A volt/ohmmeter (VOM) and the appropriate Toilet Wiring Diagram may be required for this section. Caution: Portions of this section will require that power be applied to the toilet. Keep hands away from the flush ball, motor drive arm and rotor shaft to prevent personal injury during testing and troubleshooting. The control module uses a microprocessor to provide all the automatic and timing functions.
TRoubLeSHooTING eRRoR CoDe CoRReCTIve pRoCeDuReS Condition Mode Switch in SERVICE position. Valve Open Limit Switch problem. Valve Closed Limit Switch problem. Insufficient vacuum in system. Flush valve motor relay failure. ToILeT opeRATIoN SYMPTOM 1. Toilet will not flush and water will not enter toilet bowl. Condition +5V status light is off (on far right of control module):...
Page 13
TRoubLeSHooTING SYmpTom 3. Flush valve will not close. Condition/Procedure Mode Switch is in SERVICE position: Foreign object prevents the flush valve from closing and the safety circuit locked flush valve in open position: Check for error code at “DO NOT FLUSH”...
Page 14
TRoubLeSHooTING SYmpTom 8. Water will not stay in bowl and system loses vacuum. Condition/Procedure Put Mode Switch in “Service” position: Worn or damaged flush valve ball and seal: SYMPTOM 9. Water will not shut off and overflows the toilet. Procedure Check the “WATER VALVE”...
Page 19
mARINe WIRING DIAGRAmS (cont’d) MARINE VACUFLUSH STATUS PANEL / TANKWATCH OPTION vACuFLuSH STATuS pANeL opTIoN IMPORTANT: ORANGE WIRE ON PIN 15 OF CONTROL MODULE MUST BE CONNECTED TO THE “A” TERMINAL OF THE VACUUM SWITCH REGARDLESS OF WHICH VACUUM SOURCE IS USED.
Page 20
mARINe WIRING DIAGRAmS (cont’d) VACUUM GENERATOR/VACUUM TANK AND PUMP OPTION m-SeRIeS vACuum pump AC CIRCuIT opTIoN...
mARINe WIRING DIAGRAmS (cont’d) m-SeRIeS vACuum pump DC CIRCuIT opTIoN DImeNSIoNS models 3006, 3106* models 3309, 3348, 3409*, 3448* 300 and 3400 series toilets operate with wall-mounted flush switch, and do not include flush handle on toilet. models 3009, 3048, 3109*, 3148* China toilet dimensions may vary ±3/8-inch (0mm).
E-mail: sales@aersupply.com You may also contact or have your local dealer contact the Parts Distributor nearest you for quick response to your replacement parts needs. They carry a complete inventory for the SeaLand product line. Fax: 330-496-3097 U.S.A. and Canada 330-496-3220 International U.S.A.
To obtain warranty service, first contact your local dealer from whom you purchased this product. SeaLand, vacuFlush, and Flush and Forget are registered trademarks of Dometic Corporation. Dometic is a customer driven, world-leading provider of innovative leisure products for the caravan, motorhome and marine markets.
Need help?
Do you have a question about the 3000 and is the answer not in the manual?
Questions and answers