Advertisement
FIGuRE 10. ExAMPLE OF MuLTIPLE BOARDS ShARING SAME ExTERNAL SuPPLy. REFER TO FIGuRES 8 AND 9 FOR TyPICAL wIRING. MAkE
CERTAIN LIP ON LONG POwER SuPPLy juMPER ENGAGES RETAINING TAB ON T5 OR T6 AS ShOwN IN vIEw A-A:
PCB 1
This device complies with part 15 of the FCC Rules. Operation is subject to the fol-
lowing two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Note:
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential in-
stallation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interfer-
F200-22-00
+
—
EXTERNAL
POWER
SUPPLY
FCC STATEMENT
ence will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
5
firealarmresources.com
PCB 2
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
C0781-00
VIEW A-A
I56-1900-005
©2008 Fire•Lite
Advertisement
