AEG KO-LAVAMAT 74740 User Information page 35

Problem
No water runs in.
E10
Fault code ap-
pears. The indicator
RINSE+ (SPÜLEN+,
RINCAGE+) flashes.
The washing machine
vibrates during opera-
tion or it is on an une-
ven surface.
The washing solution
of the main wash
froths up a lot.
Possible Cause
Water valve is closed.
Filter in screw connection of
the intake hose is blocked.
Water tap is blocked with
limescale or is faulty.
The transport safeguard has
not been removed.
The height-adjustable screw
feet are not correctly set.
There is not much washing in
the drum (e.g. only one
dressing gown).
The water could not be com-
pletely pumped off before
spinning because the drain-
age hose is bent
or
the solution pump is blocked.
Too much detergent was
probably used.
Instructions for use
Remedy
Open the water valve.
Close the water valve. Un-
screw the hose from the wa-
ter valve, remove the filter
and clean it under running
water.
Check water tap and have it
repaired if necessary.
Remove transport safeguard
as indicated in the instruc-
tions for installation and
connection.
Adjust in accordance with
the installation and connec-
tion instructions.
This does not impair the op-
eration of the machine.
Check the laying of the
drainage hose and eliminate
the bend if necessary, or
clean the solution pump and,
if required, remove foreign
bodies from the pump hous-
ing.
Meter the detergent exactly
in accordance with the
manufacturer's information.
35