Pyle PWPSB1102 User Manual page 3

4. Installing on the cage bar of 1.5" to 2.0". Wrap the rubber strip on the cage bar to prevent
being scratched. And then, press the aluminum rings on the rubber strip. The screw mounting
holes of the aluminum ring are aligned with the base.
• 2" Cage bar are installed using 2" aluminum ring and 120X14X1mm rubber strip.
• 1.875" Cage bar are installed using 2" aluminum ring and 130X14X2mm rubber strip.
• 1.75" Cage bar are installed using 1.75" aluminum ring and 120X14X1mm rubber strips.
• 1.5" Cage bar are installed using 1.75" aluminum ring and 120X14X4mm rubber strips.
5. Use M6X60mm screws and M6 spring washers to pass through the aluminum ring and the
base and the M6 non-slip nut at the back to fix the aluminum ring on the base as shown in the
figure. Each nut should be installed in the hexagonal groove.
3
www.PyleUSA.com