Table of Contents
Advertisement
AUTOREPEAT RECORDING
Autorepeat Recording
The same tape can be recorded over many times.
œ Follow the Before starting steps, under "NORMAL
RECORDING".
1
Press the MENU button to display the MAIN MENU.
2
Press the l (or j) button to select the "3.GENERAL
SET" line, then press the ENTER button.
ø The (GENERAL SET) menu appears.
<GENERAL@SET>
TAPE@IN@MODE@@@@@STOP
TAPE@END@MODE@@@@REW
CLOCK@ADJUST@@@@@01:00
THREAD@CHECK@@@@@N
VIDEO@LOSS@@@@@@@N
REMOTE@@@@@@@@@@@MENU
VIDEO@@@@@@@@@@@@COLOR
3
Press the l (or j) button until the "TAPE END
MODE" setting is highlighted, then press the ENTER
button.
4
Press the l (or j) button to set to "REPEAT1" or
"REPEAT2" (Refer to "Setting the Mode at the End
of the Tape." on page 21), then press the ENTER
button.
5
Press the MENU EXIT button.
6
Press the REC button.
ø Recording starts. When the tape end is
reached, the VCR will rewind it to the
beginning, and recording will resume.
ø When the end of the tape is reached, "OFF" will
be displayed and TAPE END OUT terminal
output will 0 V, until the rewinding operation
starts.
7
To stop recording, press the STOP button.
NOTES:
œ If there is an alarm trigger during autorepeat
recording, "AL" and "A" flash on the digital display and
alarm recording starts. (Refer to "ALARM
RECORDING" on page 23.)
œ If the "TAPE END MODE" setting is "REPEAT1" and
there is an alarm trigger, the recording will continue to
the end of the tape, and then the tape will be rewound
to the beginning and stop. "OFF" will be displayed on
the digital display.
To turn off the "OFF" display, press the STOP,
EJECT, FF, REW or PLAY button.
œ If "AL" appears on the digital display and the "TAPE
END MODE" setting is "REPEAT1", autorepeat
recording is not possible.
22
English
Advertisement
Table of Contents
