Basic Operation; Turning On / Off Projector - Sanyo PLV-HD100 Owner's Manual

BASIC OPERATION

1 Complete peripheral connections (with Computer, VCR, etc.)
before turning on projector. (Refer to "CONNECTING TO
PROJECTOR" on Pages 12~15 for connecting that equipment.)
2 Connect a projector's AC Power Cord into a wall outlet and turn
MAIN ON/OFF SWITCH to ON. LAMP indicator lights RED, and
READY indicator lights GREEN.
3 Press POWER ON-OFF button on Side Control or on Remote
Control Unit to ON. LAMP indicator dims, and Cooling Fans start
to operate. Preparation Display appears on a screen and count-
down starts. Signal from source appears after 30 seconds.
Current Input and Lamp status are also displayed on screen for
5 seconds. (Refer to "LAMP MANAGEMENT" on page 40.)
1 Press POWER ON-OFF button on Side Control or on Remote
Control Unit, and a message "Power off?" appears on a screen.
2 Press POWER ON-OFF button again to turn off projector. LAMP
indicator lights bright and READY indicator turns off. After
approximate 90 seconds, READY indicator will light green again
and projector may be turned on by pressing POWER ON-OFF
button.
3 Cooling fans will operate for approximate 2 minutes after projec-
tor is turned off. To power down completely, turn MAIN ON/OFF
SWITCH to OFF and disconnect AC Power Cord.
TO MAINTAIN LIFE OF LAMP, ONCE YOU TURN
PROJECTOR ON, WAIT AT LEAST 5 MINUTES BEFORE
TURNING IT OFF.
When "Power Management" function mode is Ready or Shut down, projector detects signal interruption and turns off the
Projection Lamp automatically. Refer to "Power management" on page 37.
When WARNING TEMP. Indicator is flashing, projector cannot be turned on, refer to the section "MAINTENANCE" on page 39.
When the both WARNING TEMP. and READY Indicator flashing, refer to the section "MAINTENANCE" on page 39.
Do not use the projector continuously for 24 hours or more. If using the projector continuously for long periods,
turn it off and leave it for one hour at least once during a 24 hour period.
If you use the projector continuously for long period, it can excessively shorten the life of the lamp.
22

TURNING ON / OFF PROJECTOR

TURNING ON PROJECTOR
TURNING OFF PROJECTOR
INPUT AND LAMP STATUS
30
Preparation Display disappears after
30 seconds.
Message disappears after 4 seconds.