Pc Adjustment; Auto Pc Adjustment - Sanyo PLC-XF45 Owner's Manual

Auto PC Adjustment function is provided to automatically adjust Fine sync, Total dots and Picture Position to conform to your
computer. Auto PC Adjustment function can be operated as follows.
Auto PC Adj.
1 Press MENU button and ON-SCREEN MENU will appear. Press
POINT LEFT/RIGHT button to move a red frame pointer to PC
ADJUST Menu icon.
Press POINT DOWN button to move a red frame pointer to
2
AUTO PC Adj. icon and then press SELECT button twice.
This Auto PC Adjustment can be also executed by pressing
AUTO PC ADJ. button on Side Control or on Remote Control
Unit.
Store adjustment parameters.
Adjustment parameters from Auto PC Adjustment can be memorized
in this projector. Once parameters are memorized, setting can be
done just by selecting Mode in PC SYSTEM Menu (P26). Refer to
step 3 of MANUAL PC ADJUSTMENT section (P30).
NOTE
Fine sync, Total dots and Picture Position of some computers can
not be fully adjusted with this Auto PC Adjustment function. When
image is not provided properly through this function, manual
adjustments are required. (Refer to page 30, 31.)
Auto PC Adjustment function cannot be operated in Digital Signal
input on DVI terminal and "RGB", "480p", "575p", "720p (HDTV)",
"1035i (HDTV)", "1080i50 (HDTV)" or "1080i60 (HDTV)" is selected
on PC SYSTEM Menu (P27).

PC ADJUSTMENT

AUTO PC ADJUSTMENT

COMPUTER INPUT
PC ADJUST MENU
PC ADJUST Menu icon
Move a red frame pointer to AUTO PC
Adj. icon and press SELECT button.
29