Table of Contents
Advertisement
Used to operate P-TIMER
function. (P21)
REMOTE CONTROL BATTERIES INSTALLATION
Remove the battery
1
compartment lid.
Press lid down-
ward and slide it.
To insure safe operation, please observe the following precautions :
G Use (2) AA, UM3 or R06 type alkaline batteries.
G Replace two batteries at the same time.
G Do not use a new battery with a used battery.
G Avoid contact with water or liquid.
G Do not expose the Remote Control to moisture, or heat.
G Do not drop the Remote Control.
G If a battery has leaked on Remote Control, carefully wipe case clean and install new batteries.
G Risk of explosion if battery is replaced by an incorrect type.
G Dispose of used batteries according to the instructions.
Slide the batteries
2
into compartment.
Two AA size batteries
For correct polarity (+ and
–),
be
terminals are in contact
with pins in compartment.
BEFORE OPERATION
Operating Range
Point the Remote Control toward
projector
(Infrared
Receiver) whenever pressing any
button.
Maximum operating
range for Remote Control is about
16.4' (5m) and 60° in front and
rear of the projector.
16.4'
(5 m)
16.4'
(5 m)
Replace the compartment lid.
3
sure
battery
Remote
60°
15
Advertisement
Table of Contents
