Table of Contents
Advertisement
EN 4
4.
FTP2.4E AB
4.2
Assy/PWB Removal
4.2.1
IBO Zapper Module
1
Figure 4-2 IBO Zapper module
1. Disconnect the earth cable [1] from the earth connector on
the IBO Zapper module.
2. Remove the 6 torx screws [2] and remove the shield by
carefully turning it to the left (see figure "Disconnect IBO
Zapper module").
3
Figure 4-3 Disconnect IBO zapper module
Note: See figures "Disconnect IBO Zapper module" and
"Connector 1500".
1. Disconnect the flat cable [3] from connector 1500 on the
IBO zapper module by lifting the black cable clamp and
pulling out the flat cable.
For re-connection afterwards, lift the black cable clamp of
this connector [4] and put the flat cable back in.
Push down the black cable clamp of connector 1500 after
the flat cable is plugged in.
2. Disconnect white connector (1301).
3. Disconnect the antenna cable [3] from the tuner on the IBO
Zapper module.
All manuals and user guides at all-guides.com
Mechanical Instructions
2
F_15740_021.eps
101005
F_15740_022.eps
101005
Figure 4-4 Connector 1500
Figure 4-5 Remove IBO zapper module
1. Remove the torx screws [5] and remove the IBO zapper
module from its metal case.
4.2.2
IBO Zapper Module Front Panel
Figure 4-6 IBO zapper module front panel
1. Remove the two screws [1].
2. Remove the front panel by shifting it sideways to unlock it.
4
F_15740_023.eps
101005
5
F_15740_024.eps
101005
1
F_15270_088.eps
300505
Advertisement
Table of Contents
