Serial Number Setup; Sensor Correction - Panasonic PT-AE3000U Service Manual

· Must use the window pattern of 1 080p (1 920 x 1 280).
3. Click the OK button.
7.7.

Serial Number Setup

Set the serial number if the A-P.C.Board is replaced and the product serial number disappears.
Note:
· Set the projector into standby mode (POWER indicator on the projector illuminated red), and execute the procedure in 7.7.4.
7.7.1. Setting Menu
7.7.2. Explanation of Buttons
Send:
Sends and writes the serial number to the projector.
Receive:
Receives the serial number from the projector.
Close:
Closes this dialog.
7.7.3. Equipment to be used
PC, Software for Adjustment
7.7.4. Setting Procedure
1. Display Serial Number menu.
2. Click [Send] button after inputting the serial number.
7.8.

Sensor Correction

Execute the sensor correction when EEPROM (IC1061) / A-P.C.Board or filter sensor (CF2004) is replaced.
7.8.1. Equipment to be used
PC, Software for Adjustment
7.8.2. Correcting Procedure
Clean the air filter enough before executing the correction. (If the air filter is dirty, it is not possible to correct the sensor normally.)
Note:
· When cleaning is ineffective, replace the air filter with new one.
1. Switch the MAIN POWER button ON to light the lamp. (Signals need not be input.)
Note:
· When AUTO SEARCH is operating, interrupt it by operating INPUT button.
2. Display the adjustment menu.
All manuals and user guides at all-guides.com
29
PT-AE3000U / PT-AE3000E