Advertisement
3. Specification
Parts of the electric fence energizer system
Model
Range
Power source
Maximum output Voltage
Voltage under 500ohm
Energy
Stored energy
Unless otherwise stated, values are typical and normal production tolerances of ±10% should be
allowed for
4. Installation guide
Installing the battery
Caution! When connecting the battery, be careful not to short-circuit the supply terminals.
Positioning the energiser
Install the energizer adjacent to the electric fence, preferably in the middle of the electric fence in
a position where it will receive the most sun, ideally in excess of 6 hours of full sun a day. Its
S1600
Up to 1.6km
12V, 4AH,
12V, 4.5AH rechargeable lead-acid battery
up to 8.1KV
up to 2.5KV
0.11 J
0.16 J
1 ON/OFF/Night mode switch
2 DC charging input
3 Earth output terminal.
4 Locking hole
5 Star Post mount
6 Fence output terminal
7 Locking hole
8 Solar panel
9 Battery
10 Battery box
11 Battery box fixing hole
S4000
Up to 4km
up to 8.3KV
up to 3KV
0.3J
0.4J
1 Place the energizer on a flat surface.
Open the battery compartment using a
screwdriver (see diagram below).
2 Insert the battery.
3 Connect the positive (red) lead to the
positive (+) terminal on the battery.
4 Connect the negative (black) lead to
the negative (–) terminal on the battery.
5 Close the battery compartment.
Advertisement
