Charger Settings - Teledyne TDMC+ Manual

TDMC+ Teledyne Dual Mode Charger
FCC STATEMENT This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) This device must
accept any interference received, including interference that may cause undesired operation. NOTE:
This equipment has been tested and found to comply with time limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
interference energy and, if not installed and used in accordance with the instructions, may case
harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures: A. Re-orient or
relocate the receiving antenna. B. Increase the separation between the equipment and the receiver. C.
Connect the equipment into an outlet or on a circuit different from that to which the receiver is
connected. D. Consult the dealer or an experienced radio/TV technician for help.

Charger Settings

• The charger automatically retains the settings selected at the start of a charge cycle and returns
to them at the end of a charge cycle and at the next power on.
Software Version
The TDMC only has one software configuration. Software cannot be updated by the user and does
not need to be updated. Software may change due to production variation or component
differences. A charger's software version can be determined in the field by following these steps:
1. Power unit off.
2. Press and hold any of the four buttons A-D
3. Power unit on while continuing to hold the button
Questions? Write to: support@teledynebattery.com
Or call: 1 (800) 456 0070 / 1 (909) 793 3131.
Page 14/15