Samsung RS21HB User Manual page 4

safety information
• In order to avoid the creation of a flammable gas-air mixture if a leak in the refrigerating circuit
occurs, the size of the room in which the appliance may be sited depends on the amount of
WARNING
refrigerant used.
• Never start up an appliance showing any signs of damage. If in doubt, consult your dealer.
• The room must be 1m
• The amount of refrigerant in your particular appliance is shown on the identification plate inside
the appliance.
• Please dispose of the packaging material for this product in an environmentally friendly manner.
• Pull the power plug out of the socket before changing the interior light of the refrigerator.
- Otherwise, there is a risk of electric shock.
• This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
sEVErE warning signs
• Do not install the refrigerator in a damp place or place where it may come in contact with water.
- Deteriorated insulation of electrical parts may cause an electric shock or fire.
WARNING
• Do not place this refrigerator in direct sunlight or expose to the heat from stoves, room heaters or
other appliance.
• Allow sufficient space to install the refrigerator on a flat surface.
- If your refrigerator is not level, the internal cooling system may not work correctly.
• Do not plug several appliances into the same multiple power board. The refrigerator should
always be plugged into its own individual electrical which has a voltage rating that matched the
rating plate.
- This provides the best performance and also prevents overloading house wiring circuits, which
could cause a fire hazard from overheated wires.
• Never unplug your refrigerator by pulling on the power cord. Always grip plug firmly and pull
straight out from the outlet.
- Damage to the cord may cause a short-circuit, fire and/or electric shock.
• Make sure that the power plug is not squashed or damaged by the back of the refrigerator.
• Do not bend the power cord excessively or place heavy articles on it.
- This constitutes a fire hazard.
• Have the power cord repaired or replaced immediately by the manufacturer or its service agent if
power cord has become frayed or damaged.
• Do not use a cord that shows cracks or abrasion damage along its length or at either end.
• If the power cord is damaged, have it replaced immediately by the manufacturer or its service
agent.
• When moving the refrigerator, be careful not to roll over or damage the power cord.
• Do not insert the power plug with wet hands.
• Unplug the refrigerator before cleaning and making repairs.
• Do not use a wet or damp cloth when cleaning the plug.
• Remove any foreign matter or dust from the power plug pins.
- Otherwise there is a risk of fire.
• If the refrigerator is disconnected from the power supply, you should wait for at least ten minutes
before plugging it back.
• If the wall socket is loose, do not insert the power plug.
- There is a risk of electric shock or fire.
• The appliance must be positioned so that the plug is accessible after installation.
4_
safety information
in size for every 8g of R600a refrigerant inside the appliance.
3