Haier HAIH6IESCE User Manual page 43

Electrical connection
Fig. 6  6.3
● Disconnect the device from the electric
power supply. ● Installation must be
carried out by professionally qualified
personnel with
regulations in force for installation and
safety. ● The manufacturer denies all
liability to persons, animals or property if
the guidelines provided in this chapter are
not followed. ● The power cable must be
long enough to allow the hob to be
removed from the worktop. ● Make sure
that the voltage on the serial number data
plate on the bottom of the device
corresponds to that of the domestic
environment where it will be installed. ● Do
not use extension leads. ● The earth
power cable must be 2cm longer than the
other cables. ● If the electrical appliance is
not supplied with a power cable, use one
with a minimum conductor diameter of 2.5
mm2 for power up to 7200 Watt; for higher
power levels, the diameter must be 4 mm2.
● The temperature must not reach 50°C
above room temperature anywhere along
the cable. ● The appliance is intended for
permanent connection to the power supply.
● Please note! Before reconnecting the
circuit to the mains power supply, make
sure that it is working correctly, always
check that the power cable is correctly
installed. ●
interconnection cable must be replaced by
the authorised technical support service or
by a person with similar qualifications.
Note : the product is equipped with a
Power Limitator function, which allows a
maximum power limit to be set
The limit must be set at the time of the
product's connection to the electrical
network or when the electrical network itself
is reconnected (within the following 2
minutes). For the Power Limitation setting
knowledge of
Please note!
sequence, see the Operation section of this
manual.
Installation
● Both electric and mechanical installation
must be carried out by specialised
the
personnel.
The electrical appliance is designed to be
built into a work top with a thickness of 2-6
cm in the case of TOP installation; 2.5-6
cm in the case of FLUSH installation.
The minimum distance between the hob
and the wall must be at least 5 cm in front,
at least 4 cm on the sides and at least 50
cm from overhead wall units.
NB = The recommended distances are
given as examples: when planning the
spaces, the indications of the kitchen
manufacturer must be observed.
Caution! Failure to install screws and
fasteners in accordance with these
instructions may result in electrical hazards.
Mounting
Before starting the installation:
• After unpacking the product, check that it has not been
damaged during transport and in the event of problem,
please contact the reseller or the Customer support
service before installing it.
• Check that the product is the right size for the installation
area.
• Check for accessories (e.g. bags containing screws, warranty
certificates, etc.) inside the packaging (placed there for
transport reasons). Remove and keep them safe, if present.
• Also check that there is a power socket near the installation
area.
Preparing the cabinet for installation:
The
- The product cannot be installed above cooling appliances,
dishwashers, heaters, ovens, washing machines and dryers.
- Create the cut-outs in the cabinet before inserting the hob and
carefully remove any shavings or sawdust.
- to optimise the filter installation, it is advisable to cut a slot
in the plinth to insert a grille (available on the market)
Caution!: the back panel of the cabinet under the worktop must be
removable for inspection \ maintenance.
41