Setting Up The Refrigerator; Removing The Refrigerator Doors; Tools You Will Need - Samsung DA68-01812G User Manual

setting uP tHe ReFRigeRatoR

Now that you have your new Refrigerator installed in place, you are ready to set up and enjoy the features and functions of
the appliance. By completing the following steps, your Refrigerator should be fully operational.
1. Place the Refrigerator in an appropriate location with reasonable clearance between the wall and the
Refrigerator. Refer to installation instructions in this manual.
2. Once the Refrigerator is plugged in, make sure the interior light comes on when you open the doors.
3. Set the Temperature control to the coldest temperature and wait for an hour. The Freezer will get slightly chilled
and the motor will run smoothly.
4. After powering the Refrigerator, it will take a few hours to reach the appropriate temperature. You can store food
and drinks in the Refrigerator after the temperature is sufficiently cool.
Check the accessory list below.
Water filter
(DA29-00002B) (DA80-00002C)

ReMoVing tHe ReFRigeRatoR DooRs

If the Refrigerator is too large to pass through your doorway easily, you can remove the refrigerator doors.

tools you will need

Disassemble the Refrigerator doors
1. With the door opened, remove the Top Table cap
( ) with a Flat head screwdriver, and close the
1
door.
Remove the 3 screws holding down the Top Table
and remove the Top Table(
DA68-01812G.indb 9
Hex wrench Fastener
(DA60-00143B)
).
2
Compressin fitting Compression nut
(DA62-00305A) (DA74-00070B)
Philips screwdriver 10mm Socket Wrench
Flat-blade screwdriver
Allen wrench(5mm)
Pliers
2
1
Setting Up _9
2009.8.10 9:7:45 AM