Advertisement
The assembly of this desk requires the
assistance of another person.
1. Place the top ① face down on a protected flat
surface so threaded inserts are facing up.
2. With drawers taken out of base cabinet (if unit has
them), place base cabinet ② upside down on the
top, aligning pre-drilled holes in base cabinet with
threaded inserts in top.
Using a 4mm Allen wrench or 4mm hex bit, fasten
base cabinet to top with 1/4"-20x35mm joint
connector bolts.
3. Align pre-drilled holes in leg(s) ③ with threaded
inserts in top ①, making sure the long side of leg
plate(s) is facing the same direction as the front side
of base cabinet.
Using a 4mm Allen wrench or 4mm hex bit and screw
gun, fasten leg(s) to top with 1/4"-20x15mm joint
connector bolts. These bolts will be used for either
(ELS or UNET) leg(s).
wibenchmfg.com
ASSEMBLY
Specifications are subject to change. Product
images are for illustrative purposes only and may
differ from the actual product.
NOTE: Hardware packs are included in
packaging. You may receive more hardware
than needed. Discard any extra hardware after
assembly.
4. If casters ④ & ⑤ are needed, remove glides from
leg(s) by rotating counter clockwise. If glides will
be used, skips Steps 4 & 5. Insert dual wheel
locking casters into leg(s) ④. Tighten with a 14mm
open-ended wrench.
5. Place (2) locking and (2) non-locking 75mm plate
casters ⑤ on the caster base of the base cabinet
②, aligning the holes in the plates with the threaded
inserts in the caster base. We recommend placing
the two locking casters towards the front end of the
cabinet. Using a 4mm Allen wrench or 4mm hex bit,
fasten casters to the caster base with 1/4"-20x25mm
joint connector bolts.
507 E. Grant St. Thorp, WI 54771 • P - 800.242.2303
2
Advertisement
