Advertisement
Step 8
Step 9
Step 10
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
1. Screw the hex bolts through the back of
the door. Do not forget the washers.
2. Hold the hexagon head bolts with a
wrench and tighten the cap nuts by
hand.
1. Now tighten the screw and the cap nut.
Make sure that the screw does not spin
and that the steel bracket is not dam-
aged.
2. Repeat the step on the opposite edge of
the door.
3. The assembly of the steel brackets on
your door is now complete.
1. Place one of the anti-jump discs on top
of the door near the bracket. Fasten the
disc loosely to the door with the wood
screw.
2. Also attach the other anti-jump disc next
to the other steel bracket. Then screw
both discs tight. These can prevent the
door from jumping out of the rail.
Item 61811
Page 8
11
2021-1
Advertisement
