Advertisement
Step 4
Step 5
Step 6
Step 7
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
1. Guide the rail up and hold it horizontally.
Then repeat step 3 at the other end of
the rail.
2. Now attach the screws to the remaining
holes in between.
3. After all screws have been inserted,
tighten them with the key. Make sure,
however, that they are not overtightened
so that they can be removed again.
Slit the door on the underside with a suitable tool
(7 mm wide and 20 mm deep). The slot is de-
signed so that the door can run over the floor
guide.
1. Lay the door face up on the floor and
place the steel bracket on top. Draw a
line parallel to the side edge of the door.
The distance between the edge of the
door and the edge of the steel bracket
depends on where the doorstop is in-
stalled.
2. Place the steel bracket on the line that
you have just drew.
3. Hold the bracket. The distance from the
top of the door to the first hole is 40 mm
and to the second hole is 130 mm.
4. Mark the location for the pilot holes in the
middle of the two bracket holes.
5.
Repeat step 6 on the opposite side of
the door.
1. Drill a pilot hole at one of the locations
you marked in step 6. Use a 10 mm drill
bit and drill all the way through the door.
Be careful and make sure that the hole
is accurate.
2. Repeat this for the other marked posi-
tions.
Item 61811
Page 7
11
2021-1
Advertisement
