Carrier RG10A2/BGEF Owner's Manual page 7

4. HOW TO USE ADVANCED FUNCTIONS
Press this button 2 times during one second under HEAT Mode and setting temperature of
16 C/60 F(for models of RG10B2(U2)/BGEF and RG10A2(U2S)/BGEF) or 20 C/68 F(for models of
RG10B10(U2)/BGEF and RG10A10(U2S)/BGEF).
F.P.
2
The unit will operate
at high fan speed (while
compressor on) with
temperature automatically
set to 8 C/46 F.
Note:This function is for heat pump air conditioner only.
Press this button 2 times under HEAT Mode and setting temperature of 16 C/60 F or 20 C/68 Fto activate the freeze
protection function. It will help to keep the room above 0 C/32 F (freezing point) in severe cold winter.
Press On/Off, Sleep, Mode, Fan and Temp. button while operating will cancel this function.
Press this button to start/stop Self clean or Active clean function(Model dependent).
Self clean function(some units) :
Airborne bacteria can grow in the moisture that condenses around heat exchanger in the
unit. With regular use, most of this moisture is evaporated from the unit. Under Self clean
Clean
Clean
operation, the unit unit will clean itself automatically. After cleaning, the unit will turn off
automatically.
Note: You can only activate this function in COOL or DRY or AUTO COOL(some units) mode.
Active clean function(some units) :
The Active Clean Technology washes away dust, mold, and grease that may cause odors
when it adheres to the heat exchanger by automatically freezing and then rapidly thawing
the frost. When this function is turned on, the indoor unit display window appears "CL",
after 20 to 130 minutes, the unit will turn off automatically and cancel Clean function.
Keep pressing Fan button for more than 2 seconds to activate/disable Silence function.
2s
Silence
Due to low frequency operation of compressor, it may result in insufficient cooling and heating capacity.
Press ON/OFF, Mode, Sleep button, turn on F.P.or Self clean function while operating will cancel silence
function.(Model dependent)
11
Press LED button
LED
LED
Press this button to turn
on and turn off the display
on the indoor unit.
Press ECO Sleep button under Auto/Cool/Heat mode
The set temp. will increase(cooling)
or decrease (heating) by 1 C/1 F per
ECO
hour for the first 2hs. Please refer
ECO Sleep
to the OWNER'S MANUAL for
Sleep
more details.
This Sleep operation saves energy and improves night time comfort by synchronising with the
body's metabolism. The sleep function is not available in Fan or Dry mode.
Press this button more than 2 seconds
2s
The unit will memorize
My
the current setting
My
Mode
Mode mode, Temp., fan).
My Mode function enable you to memorize or restore your favorite settings (mode, temperature and fan
speed).
Press this button more than 5 seconds
5s
LED
Keep pressing this button more than 5 seconds, the
indoor unit will display the actual room temperature.
Press more than 5 seconds again will revert back to
display the setting temperature(Model dependent).
Press this button
The unit will restore to
My
the setting you made
Mode
last time.
12