AEG KO-LAVAMAT 70630 User Information page 42

Installation and connection instructions
The special key E and the caps D
3
(2 each) and G (1 each) are sup-
plied with it.
3. Unscrew the two screws with the
special spanner.
4. Unscrew the 4 screws B with spe-
cial spanner E.
5. Remove the transport rail C.
6. Screw the 4 screws B back in.
7. Close the 2 large holes with the
caps D.
Important! Press in the caps with
sufficient strength so that they
engage in the rear panel (protects
the inside of the units against
splash water).
8. Remove the screw F, including the
sleeve, compression spring and
washer, with the special spanner
E.
9. Close the hole with the cap G.
Important! Press in the cap with
sufficient strength so that it en-
gages in the rear panel (protects
the inside of the unit against splash water).
42