AEG KO-LAVAMAT 70630 User Information page 33

Problem
Water runs out under
the washing machine.
Conditioner was not
washed in, compart-
ment æ for care
agents is filled with
water.
Washing heavily
creased.
Washing is not well
spun. Residual water is
still visible in the drum.
(2
Error code is shown
in the multi-display.
Possible Cause
The screw connection on the
intake hose is leaky.
The drainage hose is leaky.
The drain pump cover is not
correctly closed.
Washing in caught in the
filling door.
The emergency drainage
hose is not correctly closed
or leaks.
The conditioner insert in the
compartment for care agents
is not correctly attached or
is blocked.
Too mush washing probably
put in.
Drainage hose bent.
Maximum pumping height
(discharge height 1m from
the unit's standing surface) is
exceeded.
Drain pump is blocked.
If a siphon is connected: Si-
phon blocked.
Operating Instructions
Remedy
Tighten the intake hose
screw connection.
Check the drainage hose and
replace it if necessary.
Close cover correctly.
Abort program, remove
washing from the filling
door. Restart the program.
Close the emergency drain-
age hose correctly (see the
section "Carry out emer-
gency drainage"). Call Cus-
tomer Service if the
emergency drainage hose
leaks.
Clean the detergent drawer,
attach the conditioner insert
securely.
Pay attention to the maxi-
mum filling quantity (see
Program tables). In the case
of easy-care textiles, select
the program EASY IRON.
Remove the bend.
Contact your customer serv-
ice. For pumping heights
over lm he can offer you a
conversion kit as a special
accessory.
Switch off the unit and pull
out the mains plug. Clean
the drain pump.
Clean the siphon.
33