Advertisement
D. The EP-1000 should be set as the Default Windows Printer. This will simplify JETStream
configuration and use.
E. DO NOT select the Test Print option. A test print will be made after the Ethernet converter is
programmed.
F. Set the EP-1000 for Do not Share.
Ethernet Converter Setup
Before the JETStream can print to the EP-1000, the Ethernet converter must be set to the proper network
address. A special software configuration tool is loaded on the JETStream when the drivers are loaded. The
instructions below describe how it is used.
1. Open a Windows XP command window:
A. Click on the Windows Start button.
B. Click Run... then in the text box, type cmd. Then click OK.
C. Change the default directory to c:\codonics\bin.
2. Launch the configuration tool by typing:
set-ep1000
3. Follow the prompts and note the following:
A. The Ethernet address of the converter can be found on the label of the converter. It is a 12-digit
hexadecimal that starts with 00-40-17.
B. Use the same IP address that was used for configuration of the EPR1 port during driver install.
C. For direct connect or isolated networks, use the following:
Subnet Mask: 255.255.255.0
Gateway: 0.0.0.0
For larger networks, obtain the proper values from the Network Administrator.
4. When completed there should be a message indicating that the Parameters were set OK. In some
cases, the parameters may set up properly, but a "failure to verify" message may be displayed. If this
failure message does occur, do the following:
A. Type ping IP address
the Ethernet converter has been programmed successfully. If the ping fails, recheck connections
and network settings and run set-ep1000 again.
B. Close the Windows XP command window by typing exit
Windows Printing Preferences
5. Click the Windows Start button. Then click Settings... then Printers and Faxes.
6. Right click on the icon for the Codonics EP-1000.
7. It is recommended that the EP-1000 be set as the Windows default printer. If not already set, it can be
made the default printer at this time. Choose Set as Default Printer.
8. Select Printing Preferences... then click on the Layout tab. Select Landscape. This will provide
maximum printable area for most JETStream images.
9. Click the Advanced... button. Change the Paper Size setting, which always defaults to Letter, to A
or A4, as appropriate.
10. Click on MCM. You can choose from available MCM (Medical Color Matching) settings. MCM 104 and
MCM 105 were developed specially for Philips Medical Systems. MCM 105 replicates the colors of the
NP-1600 series printer for customers who prefer that appearance.
Erica Sommer
Philips Jetstream to Codonics EP-1000 Printer Setup
<Enter>
<Enter>. If a response indicating a successful ping is returned, then
Page 3
<Enter>.
4/10/2006
Advertisement
