Advertisement
3. Insert the power connector into the back of the Ethernet converter. Plug the Ethernet converter power
module into a 120 vac power source. Ensure that the Pwr indicator at the back of the converter is lit.
4. Connect a network cable to the back of the Ethernet converter as follows:
Use the straight-through cable (blue cable provided with EP-1000) if the EP-1000 and the
JETStream are part of a network.
Use the crossover cable (gray cable provided with the EP-1000) if the EP-1000 is to connect directly
to the JETStream.
5. Verify that the orange Link indicator is lit.
Driver and Network Configuration
Administrative privileges on Windows XP are required to install print drivers. By default, JETStream users
should have XP administrative privileges. If you do not have administrative privileges, please contact your
system administrator.
1. Determine the IP address to be used by the EP-1000:
If on a large network, obtain network address information from the System Administrator.
If directly connected or on an isolated network, choose an unused address that differs only in the
last section (octet). For example, if the JETStream is at 192.9.200.10, the EP-1000 could use
192.9.200.50 if no other device was already using it.
NOTE: The JETStream IP address can be determined by opening a command window (Start
cmd) and then typing ipconfig <Enter>.
2. Locate the EP-1000 driver CD which can be found in the EP-1000 shipping box. Place it in the CD drive
of the JETStream.
3. Use My Computer or Windows Explorer to browse to the CD. Doubleclick on the file ep-
1000_windriver.exe to start the automated driver loading process. Follow the prompts.
4. A special EPR1 printer port will be automatically created which must be used for the EP-1000. When the
EPR1 configuration screen is displayed, type the IP address determined in step 1 in the box labeled
Host name or IP address.
5. The Add Printer Wizard will launch automatically. Please note the following very important points:
A. The EP-1000 must be installed as a Local printer. Do not choose "Network Printer Installation."
B. The special EPR1 local port must be used for the EP-1000. Do not choose or create a TCP port.
C. When prompted for drivers, click Have Disk, but DO NOT browse to the driver CD. The driver files
will be found on the JETStream at the following path:
c:\CODONICS\drivers\win2k_xp
Erica Sommer
Philips Jetstream to Codonics EP-1000 Printer Setup
Page 2
Run
4/10/2006
Advertisement
