Advertisement
Quick Links
AIR-SOURCE CO2 HEAT PUMP HOT WATER
SYSTEM
ELECTRICAL INSTALLATION INFORMATION
This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the appliance.
Manual for heat pump hot water system:|1
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Reclaim EHPE-4540P
Summary of Contents for Reclaim EHPE-4540P
- Page 1 AIR-SOURCE CO2 HEAT PUMP HOT WATER SYSTEM ELECTRICAL INSTALLATION INFORMATION This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
- Page 2 Figure 3 Reclaim Energy heat pump internal schematic Table 2 Detail specifications of heat pump unit major components Heat pump unit: Model ID=EHPE-4540P Parameter Value Unit Power input * 0.916 Thermal output * COP * 5.24 Refrigerant CO2 (R744) ˚ C...
- Page 3 65% level Heat pump unit Figure 29 Wiring diagram of Reclaim Energy ASHP hot water system 5.5.2.1 Heat pump After removing the right side piping cover of heat pump unit, the heat pump power terminal will be accessible as shown in Figure 30.
-
Page 4: Electrical Conduit
Heat pump PCB display (where RJ45 cable should be connected to) Heat pump GPO Heat pump terminal Electrical Conduit Water pipe connections Figure 30 The wiring of power cord from heat pump terminal to the heat pump GPO The process of connecting power cable to heat pump terminal is shown in figures below. Figure 31 How to attach the power cable Manual for heat pump hot water system: classic version |35... - Page 5 Earthing Cable Supply Cable Electric Cable Press Figure 32 Attached location of power cable on heat pump terminal 5.5.2.2 Controller There are 3 steps per below: 1. Wiring of RJ45 cable from the controller module to heat pump display unit as shown in Figure 33 and Figure 34 2.
- Page 6 Connect heare RJ45 Figure 33 How to connect RJ45 PATCH cable to heat pump display unit RJ45 cable & connection to the PCB display unit Figure 34 Wiring of RJ45 cable from controller to the PCB display unit Manual for heat pump hot water system: classic version |37...
- Page 7 Figure 6 A photo of supplied controller unit CR2032 Lithium Battery holder for the real time clock battery Boost button Temperature button Menu button RJ45 Patch cable connector 230vAC power terminals Temperature sensor terminals Remote Control input terminals Manual for heat pump hot water system: classic version |14...
- Page 8 4 Character 7 segment display Power LED On Call LED Fault LED Figure 7 Detail graphic description of the controller module Table 4 Detail specification of the controller module Item Description Details Option 1: 24/7 operation Option 2 (off-peak 1 per CER method): 10 pm- 7 am User selectable Operational modes Option 3: (off-peak 2 per CER method): 10 pm- 5 pm...
- Page 9 230v Australian approved power cable & plug (pre-fitted) RJ45 10 meter patch cable (pre-fitted) Temperature Sensor & 2 meter lead (pre-fitted) Mounting screws and spacers x 4 CR2032 battery Manual for heat pump hot water system: classic version |16...
Need help?
Do you have a question about the EHPE-4540P and is the answer not in the manual?
Questions and answers