Baxi SILA RCV 300 Installation Instructions, Functioning And Maintenance page 12

ENGLISH
Description and use
This product is an electrical heater to be fitted to the
cold air inlet duct upstream of the heat exchanger. It is
intended to resolve the problem of frost formation on
the heat exchanger, caused by the combination of the
low temperatures of external air and the high levels of
moisture in the air in the areas being treated.
The connection box at the top of the body provides
access to the electrical wiring terminals, and also
contains two thermostats:
-an auto-reset safety thermostat calibrated at 45°C ±
10%.
-and manual reset thermostat calibrated at 70°C ±
10%.
Compliance
• This appliance can be used by
children aged from 8 years and
above and
reduced physical, sensory or
mental capabilities or lack of
experience and knowledge if
they have
supervision
concerning use of the appliance
in a safe way and understand
the hazards involved. Children
shall not play with the appliance.
Cleaning and user maintenance
shall not be made by children
without supervision.
• These appliances are designed
for use in residential and
commercial
appliance must be installed by a
professionally
electrician.
The electrical system to which
the product is connected must
be in
applicable regulations.
• An omnipolar switch with a
contact opening distance of 3
mm or
provided
enabling
disconnection
overvoltage
conditions.
12
persons
been
or instruction
properties. The
qualified
compliance
higher should
for installation,
complete
category
• Products equipped with single-
phase
ALWAYS require connection to
220-240V (or only 230V where
required) single-phase lines.
Any kind of modification shall be
considered
tampering and shall nullify the
relative warranty.
with
given
with
be
under
III
wiring (M)
as
engines
product