Table of Contents
Advertisement
Changing the flyweights
For transportation, storage, maintenance, tool maintenance or any other operation
outside of using the tool,
1.
Remove rotor from the desuckering head (see instructions above).
2.
Remove joint, washer and then the 4 worn flyweights (
3.
Replace the flyweights in the original position (
4.
Put washer into position and then joint. If necessary, replace washer and joint (
5.
Tighten and block the rotor on the machine.
1
3
you must unplug the tool.
2
).
2
1
).
3
)
17
Advertisement
Table of Contents
