Table of Contents
Advertisement
INDUCTION FEATURES & OPERATING CONTROLS
If the unit does not initially power on, make certain the unit is plugged in properly and that the power
supply is the correct voltage and amperage to support operation of the unit. If problems occur with
no code displayed, please contact an authorized service agent or technical service.
INDUCTION FEATURES & OPERATING CONTROLS
ADCRAFT CONTROLLER
If the unit does not initially power on, make certain the unit is plugged in
properly and that the power supply is the correct voltage and amperage
to support operation of the unit. If problems occur with no code displayed,
please contact an authorized service agent or technical service.
1.
Place suitable cookware onto the plate of induction cooker. Turn
the power switch on, the power light switch will shine, indicating the
power is connected normally.
2. Pressing the ON/OFF, the power light will shine when the unit is ON. The induction cooker will
automatically power off if there is no operation within 2 hours.
3. Pressing function, the heating light will shine indicating that the induction cooker is entering the
heating state; the default power of heating is 1200W. Adjust the power rate from level 500W-1800W
by pressing the − or + symbols while in the power function.
4. Pressing the TEMP, the keep temp light will shine, indicating the induction cooker is entering the keep
temperature state, the default temperature is 430°F. Adjust the temperature from 140°F to 460°F by
pressing the − or + symbols while in the TEMP function.
5. Adjust the timer from 0 - 170 minutes by pressing the − or + symbols while in the time function.
6. Press the ON/OFF at any time to turn off the power, stopping the cooker immediately.
COOKTEK CONTROLLER
If the unit does not initially power on, make certain the unit is plugged
in properly and that the power supply is the correct voltage and
amperage to support operation of the unit. If problems occur with no
code displayed, please contact an authorized service agent or technical
service.
1.
Place suitable cookware onto the plate of induction cooker. Turn
the power switch on, the power light switch will shine, indicating the
power is connected normally.
2. Turn the cooktop "ON" by turning the control knob to the right.
3. Place cookware containing ingredients on the cooktop.
4. Depress the Temperature Mode button.
5. Turn the control knob until the desired cooking temperature appears on the LED Display. The temperature
displayed will change from the set temperature to the measured temperature 3 seconds after the
control knob is moved. The LED will show the measured temperature until the desired temperature is
achieved.
6. To turn the cooktop off, turn the control knob to the far left until it "clicks" and the LED display is no
longer illuminated.
NOTES:
1.
UNLESS NOTED, HOLE DIAMETER TOLERANCE +/- 0.005
2.
DEBURR SHARP EDGES THAT USER MAY CONTACT
DURING INSTALLATION, USE, CLEANING, OR
MAINTENANCE.
3.
ALL DIMENSIONS TO THE OUTSIDE OF PART AS SHOWN
UNLESS OTHERWISE SPECIFIED.
4
MATERIAL
STAR MANUFACTURING
NOTED
THIS DRAWING CONTAINS INFORMATION
CONFIDENTIAL TO STAR MFG. INT'L INC.
INTERNATIONAL INC.
FINISH
NO REPRODUCTION OR DISCLOSURE
-
OF ITS CONTENTS IS PERMITTED
R
265 HOBSON STREET
WITHOUT APPROVAL OF STAR MFG.
DR :
DIG
CK.
DATE:
XXX
SMITHVILLE, TN.37166, USA
INT'L INC. ENGINEERING DEPARTMENT
T
OLERANCE: UNLESS NOTED: .x .06 .xx
.03 .xxx ± .015
FLAT PATTERN .xxx
.005
ANGLES
MODEL NO.
PART NO.
WDDI-35GM
2N-Z23153
DESCRIPTION
INDUCTION UNIT CONTROL COOKTEC
12/12/19
SHEET 1OF1
1
REV.
DATE/ECO
DESCRIPTION OF CHANG
Solidworks- File Loca
Advertisement
Table of Contents
