Setting The Timer Address; Setting The Layout Address - Rangemaster TXTIMER User Manual

Rangemaster TXTIMER –
It means switches 1,3,7 go down and 2,4,5,6,8 up:
To program second combination press C button on the front of the remote control. The red lamp on
the upper left corner will blink twice.

2.4.2 SETTING THE TIMER ADDRESS

To make the remote control compatible with certain timer use the DIP switch on the PCB inside the
enclosure. They both should be set to the same channel (have one timer number). Possible channels
are 1- 8.
1. Make sure the jumper is set to the 2-pin connector (BYPAS) on the right side from the DIP-switch
2. Set the channel on the DIP switch in accordance to the address table
press E button on TXTIMER remote control. The red lamp on the upper left corner will blink thrice.

2.4.3 SETTING THE LAYOUT ADDRESS

To make the remote control compatible with certain layout use the DIP switch placed on the PCB inside
the enclosure. They both should be set to the same channel (have one layout address).
1. Remove the jumper
2. Set the channel on the DIP switch in accordance to the address table
NOTE: All layouts should have different channels!
RANGEMASTER SYSTEMS-Maxima WarenhandelsGmbH
8010 Graz, Dr. Robert Graf Straße 64/9, Austria/Europe
remote control for TIMER timing system
Web: www.rangemaster.at
Mail: info@rangemaster.at
(refer to section
(refer to section
Phone:+43 699 10403204 Rev.date:28/01/22 Page: 7
Fax:+43 720 920 195 Order code: TXTIMER
Order code: TXTIMER
2.4.4) and
2.4.4).