Connections/Cable Locations In The Generator Cabinet (Part. B) - Siemens LITHOSTAR Multiline Installation Instructions Manual

Connections with POLYDOROS LX 30
X41
A... D
D100
SNT
X9
D160
X6
X
Fig. 8

Connections/Cable Locations in the Generator Cabinet (Part. B)

•
Route the cables in the generator cabinet as shown in Fig. 8 above, and connect them in
accordance with Table 9:
•
Install the yellow cable harness in the generator cabinet below M16. Connect the
shielding of the zipper hose to the
hose, attach it with a cable tie to the left intermediate plate of the cabinet near the floor
( /Fig. 8).
L
Rotating anode cable connection
•
Route the rotating anode cable (internally required length approx. 1 m) up along the right
side in the frame of the generator cabinet to the anode starter (
•
Connect the braided shielding (external shielding) of the end of the lead to the right side
of the starter unit under one of the clamps (
•
Connect the red cable (inner shielding) to (3/Fig. 9).
•
Strain-relieve the cable using cable ties (2/Fig. 9).
•
Connect the rotating anode cable to the breaker of the anode starter (
On breaker, contact:
Anode cable leads:
Siemens AG
Medical Solutions
D110
X200
D200
X3
X4
X5
F1 F2 F3
L
K31/R2 K31/R4 K32/R2
I / 1
G
D220
H1
K20
K30
I
M16
bolt in M16 (
I
/Fig. or 1/Fig. 9).
F
0 II / 2
RXL2-120.812.01
Rev. 02 10.04
D115
K32/K31
F
H
D165
Z
/Fig. 8). To strain-relieve the zipper
/Fig. 8).
F
F
Page 13 of 20 LITHOSTAR Multiline
CS PS 24
3 - 13
3
/Fig. 8):
System