Check List - Samsung SyncMaster 940NW Owner's Manual

Check List

Before calling for service, check the information in this section to see if you can remedy any
problems yourself. If you do need assistance, please call
Information section or contact your
Symptom
No images on Is the power cord
the screen. I connected properly?
cannot turn on
Can you see "Check
the monitor.
Signal Cable" on the
screen?
If the power is on, reboot
the computer to see the
initial screen(the login
screen), which can be
seen.
Can you see "Not
Optimum
Mode","Recommended
Mode 1440 x 900 60 Hz"
on the screen?
There is no image on the
screen.
Is the power indicator on
the monitor blinking at 1
second intervals?
I cannot see Have you locked the On
the On Screen Screen Display (OSD)
Display. Menu to prevent
changes?
The screen Is the screen displaying
shows strange only one color as if
colors or just looking at the screen
black and through a cellophane
white. paper?
SyncMaster 940NW
dealer.
Check List
Check the power cord connection and supply.
(Connected using the D-sub cable)
Check the signal cable connection.
If the initial screen (the login screen) appears, boot the
computer in the applicable mode (the safe mode for
Windows ME/XP/2000) and then change the
frequency of the video card.
(Refer to the
Note: If the initial screen (the login screen) does not
appear,
You can see this message when the signal from the
video card exceeds the maximum resolution and
frequency that the monitor can handle properly.
Adjust the maximum resolution and frequency that the
monitor can handle properly.
The monitor is in PowerSaver mode.
press a key on the keyboard to activate the monitor
and restore the image on the screen.
Unlock the OSD by pressing the MENU button for at
least 5 seconds.
Check the signal cable connection.Make sure the
video card is fully inserted in it's slot.
the phone number on the
Solutions
Preset Timing Modes)
contact the Service Center or your dealer.