Using The 10-Key Pad ( Bo; Using The Setting Button - Casio LK230ES1A User Manual

General Guide
Using the 10-key Pad (
Use the number buttons and the [–] and [+] buttons to change
the settings of the parameters that appear in the upper left
area of the display.
Setting
M d e r n P n o
Number Buttons
Use the number buttons to enter numbers and values.
• Enter the same number of digits as the currently displayed
value.
Example: To enter tone number 005, input 0 3 0 3 5.
• Negative values cannot be input using the number buttons.
Use [+] (increase) and [–] (decrease) instead.
[–] and [+] Buttons
You can use the [+] (increase) and [–] (decrease) buttons to
change the displayed number or value.
• Holding down either button scrolls the displayed setting.
• Pressing both buttons at the same time will revert to the
initial default setting or the recommended setting.
E-4
)
bo

Using the Setting Button (

4
Use the Setting button (
select the reverb type, pedal effect, etc.
1.
4
Press .
T r a n s .
2.
4
Next press until the parameter whose setting
you want to change is displayed.
4
Each press of cycles through the available parameters.
Parameter
1 Transpose
2 Accompaniment Volume
3 Song Volume
4 Touch Response
5 Tuning
6 Reverb
7 Voice Fingering Guide
8 Note Guide
9 Performance Evaluation
10 Phrase
11 Sampling Start
12 Keyboard Channel
13 Navigate Channels
14 Local Control
15 Accomp Out
16 Pedal Effect
17 Power On Alert
3.
When the parameter you want is displayed, use
bo
(10-key) to change its setting.
• The parameter setting will disappear from the upper left
area of the screen if you do not perform any operation
for some time.
• The tone and other parameters revert to their initial
defaults whenever you turn on power (page E-6).
)
4
) to access settings that let you
Setting
Parameter
Display See Page
Trans. E-13
AcompVol E-33
Song Vol E-19
Touch E-8
Tune E-13
Reverb E-12
Speak E-24
NoteGuid E-25
Scoring E-25
PhraseLn E-25
SmplAuto E-15
Keybd Ch E-35
Navi. Ch E-35
Local E-36
AcompOut E-36
Jack E-12
Demo2 E-6