Problems Related To Installation; Problems Related To Screen - Samsung SyncMaster 910MP Owner's Manual

The following table lists possible problems and their solutions. Before calling for service, check the
information in this section to see if you can remedy any problems yourself. If you do need
assistance, please call
Installation | Screen | Audio

1. Problems related to Installation

Problems related to the monitor installation and their solutions are listed.
Problems
PC It appears the PC does not
function normally.
The monitor screen flickers.
TV TV screen is blurred or
shows noise signals.
TV signal is not received

2. Problems related to Screen

Problems related to the monitor screen and their solutions are listed.
Problems
Screen is blank and power
indicator is off
"Check Signal Cable" message
"Not Optimum Mode" message
Picture rolls vertically.
Image is not clear. Picture is
blurred.
Picture image is unstable and
vibrates.
Ghost images are shown in the
picture.
The image is too light or too dark
the phone number on the Information section or contact your
| Remote Control
Ensure that the power cord is firmly connected and the LCD
monitor is on.
(Refer to the
Ensure that the signal cable is firmly connected to the PC or
video sources.
(Refer to the
Ensure that the PC or video sources are turned on.
Check the maximum resolution and the frequency of the
video adapter.
Compare these values with the data in the
Modes
Check if the signal cable is securely connected.
Connect it again securely.
(Refer to
Run Frequency
Turn on again after removing all accessories
(video extension cable, etc.)
Set resolution and frequency to the recommended ranges.
Check if the resolution and frequency set for the computer
video card falls in the range supported by the monitor.
If not, reset them referring to the current
the monitor menu and
Adjust the Brightness and Contrast.
(Refer to the Brightness, Contrast)
Solutions
Check if the Display Adapter Driver (VGA Driver) is
properly installed.
(Refer to Installing Driver)
Check if the signal cable between the computer and
the monitor is securely connected and tightened.
(Refer to Connecting to a
Check if the TV antenna connector is securely
connected to the external antenna.
(Refer to Connecting to TV)
Check "Channel system" and make sure you choose
the correct channel system.
(Refer to the Channel System)
Select "Auto Store" to configure the channel system
automatically. (Refer to the
Solutions
Connecting the Monitor)
Connecting the Monitor)
Chart.
Connecting to a Computer)
Coarse and Fine
Preset Timing
dealer.
Computer)
Auto Store)
Preset Timing
tuning.
Information under
Modes.