Check List - Samsung SyncMaster 275T User Manual

Check List

Before calling for service, check the information in this section to see
if you can remedy any problems yourself. If you do need assistance,
please call the
Symptom
No images on the Is the power cord
screen. connected
I cannot turn on properly?
the monitor.
Can you see
"Check signal
cable" on the
screen?
If the power is on,
reboot the computer
to see the initial
screen(the login
screen), which can
be seen.
Can you see "Not
Optimum Mode",
"Recommended
Mode 1920 x 1200
60 Hz" on the
screen?
There is no image
on the screen.
phone number on the Information section or contact your
Check List
Check the power cord connection and supply.
(Connected using the D-sub cable)
Check the signal cable connection.
(Connected using the DVI cable)
If you still see an error message on the screen when the
monitor is connected properly, check to see if the monitor
status is set to analog.
Press '
input signal source.
If the initial screen (the login screen) appears, boot the
computer in the applicable mode (the safe mode for
Windows ME/XP/2000) and then change the frequency of
the video card.
(Refer to the
If the initial screen (the login screen) does not appear,
contact the Service Center or your
You can see this message when the signal from the
video card exceeds the maximum resolution and
frequency that the monitor can handle properly.
Adjust the maximum resolution and frequency that the
monitor can handle properly.
If the display exceeds SXGA or 75 Hz, a "Not Optimum
Mode", "Recommended Mode 1920 x 1200 60 Hz"
message is displayed. If the display exceeds 85 Hz, the
display will work properly but the "Not Optimum Mode",
"Recommended Mode 1920 x 1200 60 Hz" message
appears for one minute and then disappears.
Please change to the recommended mode during this
one-minute period.
(The message is displayed again if the system is
rebooted.)
The monitor is in PowerSaver mode.
dealer.
Solutions
' button to have the monitor double-check the
Preset Timing Modes)
dealer.