AEG OKO-LAVAMAT 88730 User Information page 33

Problem
The drain pump for the
washing machine runs
constantly - even when
the appliance is
switched off.
Fabric softener was not
rinsed in, compart-
ment æ for condition-
ers is filled with water.
Washing heavily
creased
The washing is not suf-
ficiently spun. Water is
left in the drum.
(2
Error code appears
The door cannot be
opened when the ap-
pliance is switched on.
Remnants of detergent
are building up in the
detergent drawer.
The rinsing water is
cloudy.
Possible Cause
The Aqua Control anti-flood
system has been activated.
The conditioner insert in the
compartment for the condi-
tioner is not correctly at-
tached or is blocked.
Probably too much washing
put in the drum.
Drain hose is kinked.
Maximum pump head (dis-
charge height 1m from the
unit's floor) is exceeded.
.
Drain pump blocked.
The door is locked for safety
reasons (DOOR/LIGHT display
is off).
The programme protection
function is set.
Water tap not fully opened.
The inlet hose filter in the
coupling of the inlet hose at
the tap is blocked.
The cause is probably a de-
tergent with a high silicate
content.
Operating Instructions
Remedy
Turn off the tap, then re-
move the plug from the
mains and inform Customer
Service.
Clean the detergent dis-
penser drawer and attach the
conditioner insert securely.
Pay attention to the maxi-
mum load quantity (see Pro-
gramme tables). In the case
of easy-care fabrics, select
the EASY IRON programme.
Remove the kink.
Contact your local Service
Force Centre. For pumping
heights over 1m a conver-
sion kit is available as a spe-
cial accessory.
Switch off the appliance and
pull out the mains plug.
Clean the drain pump.
Wait until the DOOR/LIGHT
display lights up green.
Cancel programme protec-
tion (see the section "Pro-
gramme protection").
Open the water tap fully.
Close the water tap. Unscrew
the inlet hose from the water
tap and the appliance and
clean the filter.
No negative influence on the
rinsing results, use a liquid
detergent if necessary.
33