AEG ÖKO-LAVAMAT 86720 User Instructions page 36

Operating instructions
3. Whilst +Á is flashing, release the q (SOAKING) button.
The additional rinse function is enabled once the flashing has ceased.
It continues to be enabled until specifically disabled.
When the additional rinse function is enabled, the +Á indicator on
the program progress display illuminates prior to program start and
during the additional rinse.
4. If you wish to check whether the additional rinse function is enabled:
– Turn the program selector to F (SHORT SPIN).
– Press the q (SOAKING) button briefly.
If +Á flashes on the program progress display, the additional rinse
function is enabled.
Disabling the additional rinse function:
0 1. Turn the program selector to F (SHORT SPIN).
2. Press the q (SOAKING) button for at least 5 seconds.
As soon as the button is pressed +Á flashes on the program progress
display. After 5 seconds +Á ceases to flash and illuminates continu-
ously for a further 5 seconds.
3. Whilst +Á is continuously illuminated, release the q (SOAKING)
button.
Once +Á has ceased to illuminate, the additional rinse function is
disabled.
Wash-water cooling
The water is cooled prior to pumping out at the end of the main wash-
3
ing cycle (by adding cold water). This setting is only effective for
t (COTTON/LINEN) at a temperature of over 40 °C.)
Wash-water cooling is not selected upon delivery from the factory.
Select wash-water cooling:
0 1. Turn the program selector to F (SHORT SPIN).
2. Press the k (PRE WASH) button for at least 5 seconds.
After the button has been kept pressed for 5 seconds, l (Main Wash)
flashes on the program progress indicator for 5 seconds.
3. Whilst l is flashing, release the k (PRE WASH) button.
After blinking has stopped, wash-water cooling is selected. It remains
functional until it is deleted.
36