RotoBed Free Quick Manual

Quick Guide for RotoBed®Free
The remote control can optionally be connected to the right
or left side of the bed under the seat center piece.
Press down a key to operate the bed. When you
release the key, the movement stops.
Only press down two keys at a time when you want to
reprogram the bed (see below). When the remote control is
not in use, hang it on a bed rail.
TIP: You can relieve the pressure on your heels by
raising the leg part slightly. Thereby, the pressure
is distributed on your calf muscles and your heels is
free from the mattress.
Entry
For best comfort push yourself as far
back in the seat as possible. The
standard seat height without mattress is
32 cm above the floor. The optimal seat
height is when the entire foot surface
rests on the floor without supporting the
weight of your legs. Use the bed height
keys to find your favorite height.
Store the bed height by simultaneously
pressing down both keys for bed height
for 10 seconds until you hear a beep.
The bed will then automatically move to
the stored height every time the
POSITION key is activated.
Storegade 44 ∙ 6640 Lunderskov ∙ Denmark ∙ Tel +45 7550 5025 ∙
Back tilt when rotating
It is important that you sit comfortably
without pressure on the abdominal region
while the bed rotates. Standard inclination
of backrest when the bed is delivered is
45°. The inclination can be set to an angle
from 35˚ to 65˚. Outside this range, the
bed will make an alarm. Move the
backrest to your favorite inclination when
rotating.
Press down both keys for the backrest
simultaneously for 10 seconds until you
hear a beep.
Now your favorite backrest inclination is
stored, and the bed will always move to
CHAIR
this inclination when rotating.
RotoBed®
Backrest up
Leg part up
Bed height up
CHAIR POSITION
Exit
Press down the
until the bed stops in the exit position.
To facilitate getting out, the backrest can
be moved the last bit forward by
pressing the "Backrest up" key. Then use
the "Bed height up" key. In this way, you
get extra support when getting out of
the bed.
For perpendicular exit, press down both
POSITION keys for 5 seconds until you
hear a beep.
The exit angle is oblique as standard to
facilitate the transition to a wheelchair
or walker.
∙
www.rotobed.com info@rotobed.com
Backrest down
Leg part down
Bed height down
SLEEPING POSITION
CHAIR POSITION key
∙ cvr nr. 2558 9580