Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for LuCell AEGIS
Summary of Contents for LuCell AEGIS
-
Page 2: Safety Precautions
Safety Precautions Safety precautions are to prevent any unexpected risk or damage. Please read before use. ~ Be careful when opening and closing door. Finger or objects may get stuck. ~ Keep children away when operating the safe. ~ Do not hit edge of safe to avoid injury. ~ Safe is very heavy. -
Page 3: Keypad Overview
Keypad Overview Biometric (Fingerprint) START button reader Input panel Battery case Handle Outside Inside Drawer Alarm Shelf MEMORY button 1. Use the ‘On/Off’ switch on the Alarm to activate/deactivate. How to use Alarm 2. Use 1.5volt alkaline batteries (AAAx3). Keypad Lock Mode Push START button for 10 seconds Lock out mode activated. -
Page 4: Battery Replacement
Battery Replacement Flip up Display Cover Insert four 1.5V new Flip the Display Cover Alkaline batteries. Back and press tight. Attention • After replacing batteries, confirm safe is working properly before closing door. • Use 1.5Volt Alkaline batteries (AA x 4). (No lithium, rechargeable or heavy duty batteries.) Opening / Closing door The factory default password of this safe has been set as 1 2 3 4 5 6. -
Page 5: Changing Password
Changing Password Combination of 4 ~ 20 digit code can be used as a password Attention Safe can be programmed with up to 2 sets of passwords. Press MEMORY button “CodE” is on the Followed by located on the rear side of door. LCD display. - Page 6 Register fingerprints Maximum of 10 fingerprints Attention Make sure each new fingerprint works before closing the door. Press and hold MEMORY Press MEMORY Press ‘ 0 ’ button for 3 seconds. button once. to register. Position finger on the Position finger on the Registered.
-
Page 7: Bolt-Down Instructions
Opening the safe with fingerprint - If no fingerprint was registered, the safe can only be opened by the password. - “Err-04” is shown when the finger is not positioned correctly on the biometric reader, or an unauthorised fingerprint attempts access. - Dirt, sweat, injuries, cuts, scars, or wound may cause “Err-04”... - Page 8 Situation Possible Causes Measures Dead batteries Replace new Alkaline batteries Incorrect insertion of batteries Confirm correct insertion of batteries No response when START button pressed Press START for 3 seconds to deactivate Keypad lock mode ON keypad lock mode Circuit error Contact Service Centre Alarm continues ringing Enter correct password or wait 3 mintues...
- Page 9 Hotline: 6745 6800 email: enq@duro.com.sg...
Need help?
Do you have a question about the AEGIS and is the answer not in the manual?
Questions and answers