Advertisement
Quick Links
Repair Instructions
Replacing and Installing a Arc Gear on the Platform.
Elite Models that Apply: EL04, EL05, EL05-LE
Step
Description
Step 1.) Unscrew the (6) Phillips-head screws along the
bottom of the red case where it attaches to the chassis
1
of the machine. (2-front, 2-rear, one on each side)
Step 2.) Lift the red case off the chassis and set it aside.
Step 1.) Using a 9/16" crescent wrench, and a 9/16"
wrench, hold onto the bolt which is outside of the
machine underneath the platform, while unscrewing the
nut attached to the other end of the bolt, inside the
machine (below the bottom server wheel).
2
Step 2.) With the Platform detached, position it so that
the 4 rubber feet are touching the ground, and the white
plastic spacer is pointing up.
support@lobsterinc.com
Removing The Case
Removing The Platform
Phone: 800.526.4041
Tools
Picture
Case Screws (Front & Rear)
Phillips Screw
Driver
Case Screws (Side)
Phillips Screw
Driver
Platform with Nut removed.
9/16" Crescent
Wrench
9/16" Wrench
Platform being removed from
Fax: 818.764.6061
Case Removed
Chassis.
Advertisement
Related Manuals for LOBSTER SPORTS EL04
Summary of Contents for LOBSTER SPORTS EL04
- Page 1 Repair Instructions Replacing and Installing a Arc Gear on the Platform. Elite Models that Apply: EL04, EL05, EL05-LE Step Description Tools Picture Case Screws (Front & Rear) Removing The Case Step 1.) Unscrew the (6) Phillips-head screws along the bottom of the red case where it attaches to the chassis Phillips Screw of the machine.
- Page 2 Repair Instructions Replacing and Installing a Arc Gear on the Platform. Platform Being rested feet down- with magnet facing up. Un-installing and Installing the Arc Gear Step 1.) With the Platform on the 4 rubber feet, go to where the Arc Gear is located, and unscrew the 2 screws holding the Arc Gear (and Arc Gear Shield) Arc Gear screw holes (marked in in place.
- Page 3 Repair Instructions Replacing and Installing a Arc Gear on the Platform. Arc Gear screw holes (marked in red) Kep Nuts holding shield to Arc Gear (marked in Green) Step 2.) Place the new Arc Gear on the platform location (were the previous Arc Gear was). Screw in the 2 screws that you previously removed.
- Page 4 Repair Instructions Replacing and Installing a Arc Gear on the Platform. Screw from the Arc Gear poking through the Arc Gear Shield (marked in Orange) Step 3.) Screw on the 2 Kep Nuts to secure the shield to Arc Gear in place. Kep Nuts holding shield to Arc Gear (marked in Green) Re-attaching the Platform the Chassis Step 1.) Carefully line up the platform with the...
- Page 5 Repair Instructions Replacing and Installing a Arc Gear on the Platform. Step 3.) Put the Battery Negative Ground Loop over the threads of the ½ inch platform bolt, and cap it off with the bolt. Step 4.) Tighten the nut and yoke bolt until the nut can be turned by your thumb and index finger.